Certex Logo

Categories

Yale PE-12 Cordage

Yale PE-12 Cordage

New and Improved

PE-12 has been recently re-engineered boosting its strengths significantly. Using the same high tenacity fiber we use in our value packed Portland Braid, this high tenacity polyester single braid offers a single end per carrier construction which keels the rope from flattening out in service and self centers in sheaves beautifully. PE-12 comes with the same tough grade of Maxijacket urethane we use on out more expensive products. PE-1q2 is easy to splice and field repairs are easily accomplished. It is available in unlimited lengths and brilliant colors for easy identification. PE-12 is torque free and is undamaged when rigging with swivels.

Diamerter Inches (mm) Average Spliced
Break Strength*
Minimum Spliced
Break Strength*
Maximum**
Work Load 5:1
Weight
Lbs Kg Lbs Kg Lbs Kg Lbs/ 100ft Kg/100m
5/16 (8.0) 3,900 1,170 3,510 1,590 780 350 3.2 4.8
3/8 (9.0) 5,900 2,675 5,310 2,410 1,180 535 3.9 5.8
7/16 (11.0) 9,800 4,445 8,820 4,000 1,960 885 6.4 9.5
1/2 (12.0) 12,500 5,675 11,250 5,105 2,500 1,135 8.5 12.7
9/16 (14.0) 15,800 7,170 14,220 6,455 3,160 1,430 10.5 15.6
5/8 (16.0) 18,500 8,395 16,650 7,555 3,700 1,675 12.5 18.6
3/4 (18.0) 23,250 10,555 20,925 9,495 4,650 3,115 25.9 38.6
1 (24.0) 41,600 18,885 37,440 16,995 8,320 3,775 31.3 46.6

 

* Knots and abrupt bends significantly reduce the strength of all ropes and lowers maximum working load.
**Working load is based on static of moderately dynamic lifting/pulling operations. Instantaneous changes in the load up or down, in excess of 10 percent of the rope’s rated working load constitutes hazardous shock load and would void normal working load recommendations. Consult Yale Cordage for guidelines for working loads and safe use of rope.

Energy Absorption
The colored area under the curve represents the rope’s ability to do “work” and is expressed in foot-pounds per pound of rope in tension
Green working 406 ft. lbs./lb.
Red ultimate 8,738 ft. lbs./lb.

Dielectric Strength
The maximum allowable leakage for clean, dry PE-12 is 100 Micro Amperes when tested at 90KV per ASTM 1701-05 “Routine Production Test”. Absorbed and entrained moisture or impurities will increase ropes conductivity dramatically

Splice using Yale’s splicing technique document #10015101 (all sizes)

Specific Gravity: 1.38

WARNING: Prop 65: Products supplied by CERTEX USA may expose you to chemicals including Nickel, which is known to the State of California to cause cancer. For more information, visit to www.P65Warnings.ca.gov.

Related Products

Associated Wire Rope Snatch Blocks

Associated Wire Rope Snatch Blocks

Ropeblock Snatch Blocks are an excellent choice in most rigging and lifting plans. Durability and ease of use are some of the key benefits in addition to: Design Factor of Safety of 4:1 Lubricated bronze bushings Eye or oblong eye connection Sheaves, featuring...

Associated Wire Rope Standard Reeve Crane Blocks

Associated Wire Rope Standard Reeve Crane Blocks

Blocks shown in this section may be used on a wide variety of land based cranes such as mobile and crawler cranes. Standard Reeve Blocks are an excellent choice where frequent easy block change is not a required main feature, or lifting height is limited: Double...

Associated Wire Rope Round Overhaul Balls

Associated Wire Rope Round Overhaul Balls

The weight of the overhaul balls in this segment are based on average boom lengths and efficiency loss in mobile and crawler cranes. The low friction and easy to access hook swivel design makes the OHB series an excellent choice for a wide variety of crane...

Associated Wire Rope Overhaul Balls

Associated Wire Rope Overhaul Balls

The weight of the overhaul balls in this segment are based on average boom lengths and efficiency loss in mobile and crawler cranes. The low friction and easy to access hook swivel design makes the OHB series an excellent choice for a wide variety of crane...